Upgrade your KA24DE engine bay with our precision-fit KA24DE Front Wiring Guards, designed specifically for Nissan 240SX S13 and S14 KA24DE applications.

These guards provide a clean, professional engine bay wire tuck solution, securing and hiding your front wiring harness while helping keep it safely positioned away from the clutch fan and accessory drive components.

Manufactured from carbon fiber reinforced PPA (polyphthalamide), this high-performance composite offers 400°F+ heat resistance, exceptional rigidity, and long-term durability in harsh engine bay environments.

V1: Our V1 Wiring guards are suitable for OEM harnesses that are much more bulky than aftermarket harnesses. It is possible to remove the insulation from your OEM harness to reduce its size in order to use our smaller and more compact V2 wiring guard 

V2: out V2 wiring guards are suitable for most aftermarket wiring harnesses or de-insulated OEM harnesses since most aftermarket harnesses are more compact. Our V2’s have slots in the bottom for more freedom when running the distributor connector.

Proudly Made in the USA and includes stainless steel mounting hardware (V1 only). Re-use your valve cover hardware for V2. Recommended getting 3 mm longer bolts for the two front mounting mounts to account for the wiring guard thickness.

Fitment: KA24DE only. Not compatible with KA24E.

Clean wiring. High-heat durability. OEM+ fit and finish.

DISCLAIMER:

It is the responsibility of the customer and installer to ensure that all wiring, vacuum lines, and any other routed components do not place excessive tension, stress, or load on the wiring guard. The wiring guard is designed to support and organize properly routed wiring and lines, but it is not intended to withstand pulling forces, excessive weight, or constant tension.

Overfilling the wiring guard, routing too many lines through it, or allowing wires and hoses to pull against it may cause permanent deformation, warping, cracking, or breakage over time, especially after repeated heat cycles.